Skip to content
DustHazardAnalysis.ca
Menu

DHA Recommendations Implementation

How the open items in a dust hazard analysis report are ranked, closed and documented, and how they fit the review cycles.

Estimate your cost

Would you like to get pricing for the following equipment that will likely be required as a result of your study?

DHA recommendations implementation is the work that turns a dust hazard analysis report into finished safeguards: ranking the open recommendations, deciding how each will be closed, getting the engineering and installation done, and keeping a record of what changed. Many plants hold a DHA report with items still open, and a close-out plan puts them in order and sets who does what, and by when.

What is DHA recommendations implementation?

DHA recommendations implementation is the plan and follow-through that closes each safeguard a dust hazard analysis recommends, so the hazards the DHA found end up controlled rather than only listed.

NFPA describes NFPA 652 as covering hazard identification, process hazards analysis, and hazard management through mitigation and prevention. NFPA 660, the 2025 standard that consolidates NFPA 652 with five commodity standards, adds requirements for operational readiness reviews and defines management of change.

How does DHA recommendations implementation work, step by step?

Implementing DHA recommendations usually runs in five steps, from listing and ranking the open items to documenting each close-out, and the order matters because some safeguards depend on others being in place first.

  1. List. Every open item, with its hazard, location and the safeguard the DHA recommends.
  2. Rank. By the level of risk and anything that could make it worse, the factors a BC combustion risk assessment records.
  3. Decide. How each item closes: the recommended safeguard, an alternative, or a documented reason.
  4. Do. Design, purchase, installation, testing and training, in the ranked order.
  5. Record. What was done and tested, with the DHA, management program and drawings updated to match.

Which dust hazard analysis action items should be closed first?

The open recommendations to close first are the ones where a deflagration could spread, dust and ignition sources already meet, a control has failed, or a fire code article is not met, because those carry the highest risk or a legal order.

Signals that move an open DHA recommendation up the list, and where each comes from
SignalWhy it moves upWhere it is set
A deflagration could spread between connected machinery or equipmentThe hazard can reach more of the plantBC OHS 6.140 (2) (c) (ii)
Dust on surfaces could escape and fuel a deflagrationSettled dust can feed a larger eventBC OHS 6.140 (2) (c) (i)
Competent ignition sources are presentFuel and ignition already meetBC OHS 6.140 (2) (c) (iv)
A control has failed or is missingThe program must say how a failed control is handledBC OHS 6.141 (1) (d)
A fire code article is not metA fire inspector can order it correctedNFC 2020 Section 5.3; provincial fire acts

Who needs a DHA close-out plan, and what triggers one?

Any plant holding a DHA report with open recommendations needs a close-out plan, and the usual triggers are an approaching five-yearly DHA review, a BC annual program review, a fire inspection or a planned process change.

Protection items such as vents, suppression and isolation go on to the explosion venting design stage, and static items to a bonding and grounding review.

How do the five-year DHA review and BC's annual review fit in?

Open DHA items surface at two reviews: NFPA 652 requires the DHA to be reviewed and updated at least every five years, and BC requires a qualified person to review the whole combustible dust management program at least annually from January 4, 2027.

BC's management program must also be based on an assessment of how effective the controls already in place are (section 6.141 (2) (c) (ii)), which a documented close-out record supplies.

How does a close-out plan differ from a DHA update?

A close-out plan works through the recommendations of an existing DHA, while a DHA update or revalidation re-examines the hazards themselves, usually because the five-year cycle has come round or the process has changed.

A DHA update typically takes 3–6 weeks from go-ahead; a first DHA is described on the dust hazard analysis page.

What does DHA recommendations implementation cost, and how long does it take?

A prioritized close-out plan for the open recommendations in a DHA report starts at $4,000–$9,000 before HST for one process or collection system and typically takes 2–4 weeks from go-ahead; the engineering and installation it schedules are priced separately.

Close-out plan for open DHA recommendations, one process or dust collection system$4,000–$9,000Starting range, before HST. The estimator on this page gives a range for your own facility.

The cost table lists every study's starting range.

DHA recommendations questions

Does every DHA recommendation have to be closed?

Every DHA recommendation needs a recorded outcome that the next review can check, whether the safeguard was installed, changed or set aside with reasons. NFPA 652 requires the DHA to be reviewed and updated every five years, and that review is where open items are checked.

How often should dust hazard analysis action items be reviewed?

Dust hazard analysis action items should be reviewed at least at each DHA update, which NFPA 652 sets at least every five years, and at BC’s annual program review. Section 6.142 of BC’s OHS Regulation requires that annual review by a qualified person from January 4, 2027.

Who closes out DHA recommendations?

The plant owner or employer closes out DHA recommendations, with engineers, installers and suppliers doing the parts that need them. In BC, overall coordination of the management program goes to an individual who is the employer or an employee (section 6.141 (4)).

Does a process change reopen closed recommendations?

A process change can reopen closed recommendations, because the hazards they addressed may have moved or grown. Section 6.140 (3) of BC’s OHS Regulation requires the combustion risk assessment to be updated as soon as practicable after a significant change in structures, equipment or work processes.

What happens if DHA recommendations stay open?

Open DHA recommendations leave the hazards the DHA found without the safeguards it called for, and they come up again at the next review or inspection. In BC, the program must also include procedures for responding to the failure of a control (section 6.141 (1) (d)).

Sources

  1. NFPA 652, Standard on the Fundamentals of Combustible Dust (product page) (opens in a new tab), National Fire Protection Association.
  2. NFPA 652, Combustible Dust Awareness and Hazard Evaluation (online training series) (opens in a new tab), National Fire Protection Association.
  3. NFPA 660, Standard for Combustible Dusts and Particulate Solids (opens in a new tab), National Fire Protection Association.
  4. Approved amendments for Part 6, Combustible Dusts, in the Occupational Health and Safety Regulation and the Prevention Manual (opens in a new tab), WorkSafeBC.
  5. National Fire Code of Canada 2020 (opens in a new tab), National Research Council Canada.